HI ALL
the "autoconnect loop" will not happen again, but I did not understand how and what to do, even following the manual.
Other notes
If you are using auto connect to a talkgroup, it is advisable to check “Disconnect reflector on auto connect”. If it’s enabled, openSPOT will automatically disconnect the currently active reflector after connecting to the server. This is useful if you only want to use a talkgroup, but the server always links you to a reflector automatically. Do not check this if you are using auto connect to a reflector ID.

Note that the Homebrew protocol does not support auto reflector connecting. openSPOT uses a workaround, it starts a short, empty call to the given reflector/talkgroup ID, so the server will connect the desired reflector/talkgroup. These periodic empty calls will show up on the BrandMeister dashboard. If this bothers you, set auto connect interval to 0, or disable auto connect. Sorry, I do not understand perfectly the manual where you write about TalkGroup (TG) and REFLEKTOR "auto connect", we here call all TG.

Using OpenSpot in /M or /P, changing the cell LTE/4G, which probably happens OpenSpot lose the connection and then if not reactivated TG, OPenSPot not linked?
Which setup in this case would be optimal?

Definitely see every 600 seconds, your name scrolling on the BM dashboard is quite loud, even when for example you are not active or reachable. And if I put every hour as "3600" ?

How I do stay connected to my Brandmeister and at a fixed TG, without being in continuous "controlled" transmission loop with the Connector to the BM (with 1 second of TX noise without TX) also using it in /M where I could losing and regaining the connection ??

With AUTOCONNECT DISABLED:
Status

Active connector: Homebrew
Connected to: N/A
Modem mode: C4FM
Modem RX/TX frequency, power:
433.025000/433.025000 9%
Status: standby

Not connected! like N/A

OpenSPot may not occur if connected avoiding going to transmit the ID and create the noise of 1 second each time across the network?
If you stay connected on the TG91, active every repeater in the world every 10 minutes unnecessarily, and noising all prioritary repeater around the world...

I set "Auto connect interval (sec):0" then if restart or connection los , OpenSpot reconnect My TG, But then what happens during the normal connection, OpenShot would notice be disconnected if you are just QRV?

Thanks
73's