Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Web Interface in AP Mode stops working
DL1DOK
After configuration of an connector the web interface in AP mode stops working. Only after a factory reset it is working again. Please see attached screenshot of the corrupt web interface in AP mode.
HA2NON
This screen you see means that the openSPOT2 has already exited AP mode, stopped broadcasting it's Wi-Fi network but your tablet has not detected yet that the Wi-Fi network "openSPOT2 AP" went offline and not yet closed the webpage. Just close the page, connect to the same Wi-Fi network you've set for the OS2 and then you can open the web interface.
DL1DOK
Sorry, but it that does not work. I always get the same screen.
HA2NON
Can you complete the init setup (country select, Wi-Fi network select) when the OS2 is in AP mode?
After that, does the OS2's LED blink green or green/yellow signaling that the OS2 is connected to your Wi-Fi network?
DL1DOK
I only get this screen. No init...
(Firmware v24)
HA2NON
Seems like your phone's browser has Javascript disabled. Please try using another browser (Chrome for example). You can also try opening the init setup by opening
http://192.168.99.1
after you've connected to the "openSPOT2 AP" Wi-Fi network.
DL1DOK
Same result with Chrome. JS is on in both cases.
DL1DOK
After a factory reset it is working again...