W9AC
Been enjoying my OpenSpot2 for the last few days. One issue...
AutoCal does not seem to function. Setup notes...
1) Using latest OpenSpot2 firmware;
2) Tried two Yaesu C4FM transceivers with ample signal strength;
3) Ensured OpenSpot2 and Yaesu on same frequency;
4) Ensured C4FM Modulation Type;
5) Keyed mic for up to 5 minutes while in AutoCal mode;
6) AutoCal display shows "Seaching for a transmission...1/3" never changes.
Clues?
Paul, W9AC
HA2NON
You only need to use the AutoCal if you have voice quality issues using the openSPOT2's built-in local echo service.
Make sure half deviation is turned off in the radio, or if it's turned on, use C4FM Half Deviation modem mode.