mru
After update to V34 the openspot2 is constantly connecting and disconnecting to my access point. It only keeps about 10 seconds connected, then disconnects and reconnects, leaving the openspot2 unusable. I rebooted the accesspoint and openspot2 several times with no result. How to recover from this situation?
Regards, Michael
mru
In the meantime I did a factory reset, then I could connect and get it connected to the accesspoint, but after about 5 minutes the problem reappeared. It was in the state of looking for my saved config file, so the openspot was in a clean state after factory reset with no config loaded when the problem reappears.
Tyrbiter
The changelog for v34 (which is a beta) shows that the WiFi module firmware has been updated in this release.
I would suggest that you downgrade to fix it, I think v32 is the latest non-beta version.
mru
In the meantime I put the openspot in another room, connecting wifi to a wifi repeater instead of the wifi router, until now the openspot is permanent online...
mru
10 hours later the wifi connection is lost again, and I had to power cycle the openspot to get it online again.
Is it possible to go one version back from V34 to V32 and flash the wifi module back to the previous version?
HA2NON
Please contact
info@sharkrf.com
and refer to this thread.