Stewmair
My OpenSpot 2 and my OpenSpot 1 no longer connected. "Connection Authentication Failed".
A red on/off switch appeared beside my hotspot on the dashboard.
I am afraid I may have been excommunicated because I did not notice my OpenSpot 1 was active. It may have caused looping for which I humbly apologise and will change my operating frequency on my OpenSpot 1.
Perhaps I have it all wrong. but where do I go from here?
HA2NON
Connector authentication failed means you are using an invalid server password. Check your BrandMeister Network SelfCare page. If you have hotspot security enabled there, then you have to use the server password you've set there. If hotspot security is disabled, then you have to use the default server password "passw0rd" (without the double quotation marks). If you are using the UK server, then the default server password is "passw1rd" (without the double quotation marks).