Please do the following:
- You can reconfigure the Wi-Fi connection if you switch back the openSPOT2 to access point mode by pressing the button for 3 seconds.
- The openSPOT2 will start broadcasting it's own Wi-Fi network called "openSPOT2 AP", indicated by white LED. You can connect to this network using your browser device (phone/tablet/computer). The initialization setup will pop up, where you can select the country of operation and configure a Wi-Fi network for the openSPOT2 to connect to.
- Make sure you've entered the Wi-Fi password case sensitive.
- After you've chosen the Wi-Fi network and entered the password, the openSPOT2 stops broadcasting it's own Wi-Fi network and starts connecting to the selected network. At that moment, your browser device (phone/tablet/computer) will disconnect from the openSPOT2's network. What you have to do now is to connect to the exact same Wi-Fi network with your browser device as you've configured for the openSPOT2.
- Place the openSPOT2 close to the Wi-Fi router.
- If you have WEP encryption on your router, then make sure the password is ASCII, not hex. The openSPOT2 only supports ASCII WEP passwords. The best is to switch the encryption to WPA2 or WPA because it's much safer.
- Make sure you have enabled 2.4GHz Wi-Fi, not just 5GHz.
- If it still does not work, try switching Wi-Fi channel on your Wi-Fi router. Only channels 1, 6 or 11 should be used (see explanation here:
https://www.metageek.com/training/resources/why-channels-1-6-11.html
)