W1BFT
Openspot2 changes from the talkgroup I left it on at shut down to talkgroup 91 each morning when I turn it back on. This is very frustrating considering I am driving and find it very difficult to correct. Can you explain why this is happening? Also, this is not a new issue the Openspot2 has been doing this for sometime, I just haven't written you regarding it.
HA2NON
Which connector and modem mode do you use?
W1BFT
I am cross banding from c4fm to dmr the talk is on setup on Brandmeister as a group call but the number is private so I don't want to publish it for obvious reasons. I may not have mentioned this in my original post but I can be speaking within the talkgroup to friends and they report seeing another dmr id pop up on their radio screen and my transmission they tell be becomes broken. The Openspot2 seems to default
to talkgroup 91 even though I use 4000 disconnect and reconnect to my preferred talkgroup. I quick calls set up within tools, this is how I connect and disconnect.
HA2NON
Is the "Auto connect to ID" different than 0 (Homebrew connector setting)?
What is the "Route cross mode calls to ID" setting's value?
W1BFT
Sorry for the delay in responding. I have been out of action for a while. I tried searching for the "Auto Connect ID" and "Route cross mode calls to ID" setting's value" but cannot locate either within the Openspot dashboard? Please advise as to where within the dashboard I can locate.
Thank you
HA2NON
You can see these settings if you enable Advanced mode and open the Homebrew connector settings on the Connectors page.
W1BFT
Hi I have attached pictures from my Connectors page. I should note if I haven't already I am crossmoding
C4FM to a private DMR which show in the attachment. I should also note the problem still exists where
my friends see other call signs pop up while I am transmitting and my transmissions are choppy while this is happening.
HA2NON
There are no pictures in your post. Can you repost them?
W1BFT
I am not sure why the attachments did not upload but let's try again.
Ok, I tried but the jpg files has a yellow triangle that say when clicked on
"the image file you tried to attach is invalid. I don't understand why, I can
open the file with no issues. The two files are only 5.7 MB each.
HA2NON
Please send the images to
info@sharkrf.com
and refer to this forum thread in your email.