Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Not able to switch dstar reflectors
W0LRF
I'm set to ref 030C....... when i try to switch to a different reflector (after unlink).... the openspot2 goes into special connector...... not the new reflector...... the only way I can reconnect is to go to the the web link and reconnect.
N0RUA
Strange, you shouldn't need to specifically unlink. Are you doing it through the web interface or through your radio?
If your radio, you should just be able to send something like "REF001CL" and key up, and the openspot will switch over.
W0LRF
Thanks..... I'll try that
HA2NON
The unlink command switches the currently active connector to the Null connector. Please see the bottom of this user manual page:
http://manuals.sharkrf.com/openspot2/en/control-calls.html#page-top
W0LRF
ok... I think i undestand what you are saying...... so if i hit unlink..... i will go into a null.
to link up again.... I would just go to "link to reflector" XYZ..... right?
HA2NON
Yes
W0LRF
Cool,...... Thanks