HamScanMan
Hello:
I have a few Openspots and recently one of the OS2's seems to reset, or at least, flashes Yellow/Green. When I open the web interface (its slow), the device is sitting at the quick setup page. The last known good status was connected to REF30/Dstar.
To get it back and funcrional, I go to the Connectors Menu and see the Active Connector is NULL. I change to REF/XRF and it starts working again So, its not a full reset, just jumpoing into a NUll Modem mode.
This has happened 4 times in the last month and its becoming an unreliable device.
Do I have a hardware defect? Anything I can check?
FYI, I have other OS2's and an OS3 in same room, same WiFi, no issues.
HamScanMan
Nothing sent from transceiver. Can this be from the reflector? I have been leaving this linked to ref30.
Tyrbiter
Nothing sent from transceiver. Can this be from the reflector? I have been leaving this linked to ref30.
30C is pretty busy, maybe they have blocked your IP or callsign? Or implemented some sort of disconnect for people that don't transmit occasionally?
HA2NON
You can see the reason of the connector switch in the device log on the Status page. Make sure Advanced mode is turned on at the bottom right of the web interface to see the device log.
HamScanMan
Thanks. Will do the following.
Check log
Change reflector and put another openspot on tef30.
Its not blocked, when I change the connector, it comes right back on. I do wonder if they can send a command to make my os2 go to a null connector.
HA2NON
DTMF commands coming from the network are ignored by the OS2.