Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Openspot2 tx not working
Louwrens
I didn't use my openspot for a couple of monts but the openspot is always online.
Than this morning i try to make a contact but tx not working. Setting looks fine en RX is no problem.
It's an Openspot 2.0
And working via a repeater is no problem
What could it be?
Louwrens
PD3LPA
HA2NON
Do you mean that you don't hear the openSPOT2's transmission on your transceiver?
If yes, does the modem LED blink red when the OS2 is transmitting?
Is the TX power set to 100% on the Modem page?
Louwrens
I see nothing on Brandmeister dashboard if i transmit en nothing on the status. The led looks good en is red when there activity, power is 100%.
I have nothing done on mij porto since i last used it.
HA2NON
What kind of transceiver do you use?
Louwrens
Sorry for the Delay.. but some private problems.
But i am using the Alinco DJ-MD5
I receive fine, but TX not working.
HA2NON
Please run DMR AutoCal, or manually adjust the RX offset on the Modem page in +-100Hz steps for the lowest BER. You can verify settings using the openSPOT2's built-in local echo service on DMR ID 9999.
Louwrens
Where can i find the RX offset on the Modem page?
You mean
http://openspot2.local/#modem
?
I can not find such thing
Louwrens
Yess i found and it works! Tnx!!!