Redraider68
My OS2 is now a very small paper weight. Have been trying for weeks to open the web interface. Will connect to wifi-green or green/yellow--but the web interface will not open. Use the Shark RF interface and it will just spin and say "connecting" or I will just get a blank page. If I go through the entire initialization process--AP mode etc.-I can get the configure wifi screen. I will then select the home wifi network while the computer/ipad/iphone is still connected to openspot2. The screen will pop up directing me to connect the computer/iphone/ipad to the same network which I will then do. Unfortunately I will then receive a message the connection has been interrupted or no internet. Meanwhile the OS2 will connect to this network but when I go to the SharkRF interface I get the spinning or blank screen or cannot connect. I have tried waiting to connect to the home wifi after i have connected the OS2 but this just leads to a no internet or other error message. NO VPN is on and the Linksys smart router does not have a client isolation feature. The OS2 does show up on the Linksys smart screen. I took the OS2 n the care where it was configured with the IPhone but same result, Will recognize and connect to the phone but I cannot open the interface. Ready to use it for target practice. Any suggestions other than connect to the same network or disable client isolation. Any help or thoughts would be appreciated. Tim KC8MBN PS in the meantime my $78 pi star hotspot just chugs along.
