When using AutoCal on the OS4 Pro the process continues to restart after displaying "Finished".
Pressing the Save button either before or after the process makes no difference.
When the process finishes the found RX offset is automatically stored. You don't need to click on Save. You only need to click on the Save button if you change the AutoCal connector settings.
The question is why after automatically saving it continues to restart the process over and over?
Shouldn't the calibration process stop when "finished" is displayed?
It stops for 10 seconds and it starts again.
IMO, it would be less confusing if the process ended after displaying "finished".
When it restarts it can appear that the process wasn't successful.
Eliminating the automatic 10 second restart and creating a Re-Start Calibration would be a good idea.