Sorry for the long delay in responding. I have been sitting watch the OPenSpot so that can observe the lights. The light has been pulsating green the entire time that I have been watching except for a brief period when it flashed red. There is one profile loaded:
After 4 cycles of disconnecting (I did not nothing) the OPenSpot finally connected. The entire time the light was green except as I mentioned above a short burst of the red light flashing during one of the attempts to restart. Until the OPenSpot actually connected all the screen *(Status, Connector, Modem, Setting and Network) were grayed out and I could not have been able to make changes if I wanted during the short periods when it was connected. After the completion of these cycles, it was 4 this time (attempting to connect) the system is back, and I am sure working. All screens are accessible and available and not grayed out. The light is still steady Green, but there is no traffic on the one profile loaded, YSF Reflector.
As mentioned above, I really like this OPenSpot4 and wished that I would have gotten the Pro. I am far from an expert with this OPenSpot, but that is why I bought it. The reviews I read and said the best and easiest HotSSpot to use and setup.
I do not know if this something I am doing wrong or with OPenSpot but I believe I have almost reached my limit on trying to get it to operate correctly or where I can trust it. I am hoping you can provide some insight on what I may be doing wrong. I do not take anywhere because I never know if it is going to work.
Ron
