AllStar Serve Connectors List

SeanBaxter

I have two nodes for AllStar. They are registered and active in the Allstarlink.org database. Only one of the servers/nodes show up in the dropdown list in the M1KE web Server Connectors list. How do I get the second node to appear for a connection?

HA2NON

Our server list updates daily. Make sure your nodes are continuously online and they set up to accept web transceiver connections (both in your server's Asterisk config and on their allstarlink.org node settings page).

Vk4my

HA2NON Thankyou. I was about to put up a message re this same subject until I came across this post. I will leave my new Node running so that it will appear in your list of active Nodes.
Is there a UTC time that “Allstar updates” on the Shark RF servers are made?
Thanks Mike
Australia

SeanBaxter

My second node finally appeared in the dropdown list. I was turning the ClearNode off at night. It took two days of leaving it on 24/7 for the node to get listed. Thanks.

HA2NON

Make sure your server runs properly all the time.

Note that you can set up your M1KE to connect to servers not in the list by enabling Advanced mode at the bottom right of the web interface and setting up the IAX2 connector on the Connectors page in AllStarLink mode.