Cross mode issue

o00scorpion00o

Hi All.

I can switch profiles fine for D-Star just can't talk on a Reflector.

I connect to any D-Star channel , for example, REF30C and key up, it connects fine, I have programmed in 13003 into the radio but when I key up again to talk it appears to be sending 13003 to the openspot 3 again and it just re-connects to REF30C , I can't actually talk on the reflector all that happens is it keeps telling me connected to REF30C.

This started happening a good while ago but I got so frustrated with it that I haven't bothered until now to try sort it out again.

It appears to me that when it was working, it connected to 30c fine and when I keyed up again it knew I was already connected and would allow me talk but it appears as if now it's always thinking I want to connect even after already connecting.

I hope all this makes sense ?

Thanks

Mark

HA2NON

Set the destination callsign in your transceiver to CQCQCQ.

o00scorpion00o

HA2NON

I can't do this from Anytone 878 ?

Is there a way to do it from Openspot ?

I don't remember how I got it to work before, very strange.

HA2NON

In case you are using a DMR transceiver then you have to transmit to TG9 if you are using a D-STAR connector.

o00scorpion00o

HA2NON

Yes this works, I just use last call reply, don't know how or why but I seem to remember it being a lot easier......

Thanks for your assistance.

Mark