P25 Not transmitting after network traffic

KD7LMN

Hello, I am having an issue with P25 not transmitting to the network after I receive network traffic. I am on V32. When I first connect I can transmit out to the network as many times as I want, but as soon as I receive any network traffic the M1KE device will not send traffic to the network, on the status page shows that I an transmitting, but my traffic is not making it to my reflector.

As a side note a friend of mine was helping me test this, he is on a M1KE as well. When he first keyed up his traffic made it to me, but had an ID of 0, not his DMR number like mine has. I did notice there is no place to put in a P25 ID.

I understand that this is a beta version and I wanted to bring this to your attention, thanks for your time in this matter.

Rich KD7LMN

HA2NON

The DMR/CCS7 ID you've set at the owner info will be used as the source ID for outgoing calls. Please post a screenshot of the call log of your outgoing calls which can't be heard.

KD7LMN

Here is my call log after I receive network traffic, as you can see the M1KE is transmitting but it is not showing in the call log.

I have also included a screenshot of the console log during that time as well if that helps.

As a side note I did test P25 on an IP Connect server I have setup and it works fine that way.

Thank you for your time.

HA2NON

Your call log shows an incoming call from the network with your ID as the source. This indicates that you have another client (hotspot or software) also connected to the server with the same ID. Please disconnect all other clients as this may confuse the server and cause the behavior you've described.

KD7LMN

I would understand that concern if the problem was receiving traffic from the network, but that is not the case, it is the fact that the M1KE device does not send traffic to the server after it receives any traffic from the server. I have tested this with a friend of mine that also has a M1KE device and it is the same for both of us. As you can see from the first screenshot, the M1KE is transmitting but the traffic is not going out to the network. It should not make a difference if there is an another PI-Star device connected to the server as it is the radio that send the ID.

I hope I am making this issue clear enough, yes I used a PI-Star device to get the screenshot, but when we tested this the first time it was only 2 M1KE devices used. That should not confuse the server.

Thanks for your time.

Rich

HA2NON

Sorry, but we can't reproduce the issue. Try using a different server.