Profile or no Profile

majorgearhead

I have an OpenSPOT4 Pro. I use this with a single DSTAR radio (ID-52a Plus). The connectors I use are DSTAR, YSF, and DMR. So far I have each of these in their own profile and I use YOUR Call codes to switch profiles. This works fairly well, but I was wondering if this is the best way to do it when you only have one radio, or if I should probably simplify it and have one profile with all of the connectors configured, accessing them by connecting to a room or DMR ID depending on the service.

HA2NON

You can also switch connectors and profiles using DTMF codes.

majorgearhead

HA2NON

Indeed, however my ID-52 has no keypad so entering DTMF codes are a little more cumbersome. I have see this go both ways. Some say use the same profile for one radio, but if there are connectors that you have to have different backends, for instance TGIF, BM, then use a different profile for each of those. I need to test and see which is less cumbersome, separate profiles, or one profile with all connectors configured.