I just signed up for using SVXLink. My firmware version was just upgraded to V69.
The following is the info I received for my SVXLink account:
Owner: KC9SVO
Username: KC9SVO-T
Reflector: North America
Server / FQDN: north.america.svxlink.net
Port: 35300
Password:xxxxxxxxxxxxxxxxx
My Connector settings for SVXReflector are as follows:
SVXLink/SVXReflector
Server:
north.america.svxlink:35300
Server address:
north.america.svxlink
Port (TCP+UDP):
35300
Custom server: 🛈
Add server Remove
Login callsign:
KC9SVO-T
Authentication
Mode: Password Certificate
Password: (show)
••••••••••••••••
Talkgroup:
3109312
Keepalive interval (sec):
5
RX timeout (sec):
30
Connect retry interval (sec):
10
I continually receive this error message: SVXReflector server doesn't accept connection.
I am not sure what else to do. I am fairly new to the DMR world.
Any assistance would be appreciated.
Gene (KC9SVO)
I noticed I needed to change my Login callsign to KC9SVO (without the "-T"), but that did not solve it