I have seen on the Internet we can use the last 5 digits of our DMR ID for use
on NXDN but I also have seen where we need a new ID# for NXDN.
I am not sure which is true but I still could not get it to work.
Does anyone know about the ID requirements?

Jerry
WA4CSS

I tried using my Fusion radio in crossmode to NXDN. When the local repeater keys up,
my Fusion radio keys up and all is well.
When I key my Fusion radio, I cannot bring up the local NXDN repeater.
I probably have a setting messed up but I have tried everything I can think of.
Any ideas?

Jerry

That seems to have solved the problem.
Thank-you!

Jerry
WA4CSS

We have been experiencing momentary dropouts when using the OS2 on FCS Fusion reflectors. Every few seconds we would get a very short dropout on receive and we are told on transmit also. This does not occur using the OS1 on the same network. This happened using the cell phone wifi and also on the ho...

Thank-you HA5OGR for the screen prints.
From the first one you sent, my call is shown. (WA4CSS)
Apparently my setup is working and it looks like
a link problem with our local repeater.
Thank-you for sending.

Jerry

Still no luck. I will try again later.

Under "Default cross mode source ID:"
Is this area looking for a talkgroup or NXDN user ID?

Settings all look good but still no connection.

I have just updated the firmware on the OS2 so I can try NXDN. I connected to TG1200 which I can monitor on a local repeater. I am operating in crossmode to C4FM. When the repeater is keyed up, I can hear it on my C4FM radio through the OS2. When I key up on the C4FM radio, I cannot bring up the loc...

No, I have been using http://openspot2.local/
which has been fine up until now.

I just tried sharkrf.link and that did work after a little delay.

Jerry