Cannot connect to web interface after firmware update

Post Reply
Kn4dnl
Posts: 10
Joined: Sat Jun 15, 2019 11:55 am
Location: Dade City Florida USA

Cannot connect to web interface after firmware update

Post by Kn4dnl » Mon Jul 01, 2019 9:20 pm

I updated the firmware today and I can establish Wi-Fi network in access point mode, but cannot open the web interface. Prior reflector etc still functioning.

moreychang
Posts: 32
Joined: Thu Aug 17, 2017 2:03 pm

Re: Cannot connect to web interface after firmware update

Post by moreychang » Tue Jul 02, 2019 4:01 am

Please try to use

https://sharkrf.link

to access the web interface.


Sent from my iPhone using Tapatalk

Kn4dnl
Posts: 10
Joined: Sat Jun 15, 2019 11:55 am
Location: Dade City Florida USA

Re: Cannot connect to web interface after firmware update

Post by Kn4dnl » Tue Jul 02, 2019 12:32 pm

It looks like the problem is my wi-fi network. I am using an Orbi ac3000 system with one satellite.
When I am in the room with the base, it works fine. When I try to use it when both devices are connected to the satellite, it does not. If I can figure it out, I will repost for others who may have the problem.

Kn4dnl
Posts: 10
Joined: Sat Jun 15, 2019 11:55 am
Location: Dade City Florida USA

Re: Cannot connect to web interface after firmware update

Post by Kn4dnl » Tue Jul 02, 2019 2:41 pm

Problem was user error. The Orbi Wi-Fi satellite needed to be “re-synchronized “.

Don’t know why, but it now works fine using sharkrf link.

K3JRZ
Posts: 8
Joined: Fri Mar 03, 2017 9:21 pm

Re: Cannot connect to web interface after firmware update

Post by K3JRZ » Sun Jul 07, 2019 5:31 pm

I'm having the same issue after downloading v47. Rebooting my router, rebooted my computer. Tried the IP address of my OpenSPOT2, the sharkrf.link, and the openspot2.local url. Nothing.

The OS2 is pulsing green indicating that the openSPOT2 is connected to the selected server and is standing by. All I did was download the new firmware. My OpenSPOT2 was working before doing so.

The only thing I haven't tried yet was doing a factory reset on the OpenSPOT2.

UPDATE: I pulled the USB/power cable and held the button in while plugging the cable back in and that seems to have done the trick. Everything is still configured as before. WEIRD.

Post Reply