Page 1 of 1

How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Thu May 03, 2018 3:28 am
by VE3WZW
Can this be setup on a Raspberry Pi 3, is it the same
please offer any suggestion or documentation ?

THANKS in advance

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Thu May 03, 2018 7:15 am
by HA2NON
You can see the instructions in the README at https://github.com/sharkrf/srf-ip-conn-srv

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Wed May 22, 2019 8:38 am
by toups
Hi chaps,
did you finally manage to get it running on RasperryPI3 ?
I'd like to understand if this is powerfull enough to manage DMR traffic without latency.

Thx
rgds

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Wed May 22, 2019 9:08 pm
by n6cid
Question: When you say latency are you referring to processing power or internet lag or latency?

I have ran several Pi3-B with wifi to an attached MMDVM devices with out much trouble. Although the only source for the software has been supplied by the guys at Pi-star...

http://www.pistar.uk/downloads/

Check them out...:)

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Thu May 23, 2019 6:25 am
by HA2NON
The SharkRF IP Protocol Connector server will run fine on the Raspberry Pi.

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Fri May 24, 2019 5:46 am
by toups
many thx for the confirmation about compatibility and no performance issue, with The SharkRF IP Protocol Connector server running on Raspberry Pi.
73

Re: How to setup SharkRF Connector Server on RaspberryPI3 Linux

Posted: Fri May 31, 2019 4:18 pm
by vocoder
I run mine on a Raspberry Pi 2. I've had no issues. Runs great.