HA2NON How to change port to remote into Open Spot

Post Reply
K9CRT
Posts: 7
Joined: Fri Jan 27, 2017 5:28 am

HA2NON How to change port to remote into Open Spot

Post by K9CRT »

I have the open spot at a remote repeater site and need from time to time to remote access into it. Now it is on port 80 which is used for another repeater at my site so my question is how to change this to something other than port 80. I have looked through the menus and I am sure I am missing it.

Also I noticed we have a double beep when using the Open Spot at the end of transmission ? a friend here also stated his is doing this double beep since updating to the latest firmware. Could this be changed by the end user ?

Thank you Doug K9CRT
User avatar
HA2NON
SharkRF team
SharkRF team
Posts: 5458
Joined: Fri Mar 25, 2016 3:33 pm
Contact:

Re: HA2NON How to change port to remote into Open Spot

Post by HA2NON »

I suppose you hear the double beep in C4FM mode - because of the RX confirmation. You can turn this off on the Settings page, C4FM settings section (Transmit RX confirmation setting).

Currently there's no setting to change the HTTP server's port from 80. You can set a different port to forward on your router. For example, set port 8080 to forward to openSPOT's IP:80.
Norbert Varga, HA2NON
SharkRF Team
Post Reply