I must have a setting wrong

User avatar
WB5JJJ
Posts: 79
Joined: Sun Dec 04, 2016 8:06 pm

Re: I must have a setting wrong

Post by WB5JJJ »

KO3F.

In the DMR AutoCal function, there is no indication on the status bar for about the first 5 seconds of steady key down (no audio needed) of your radio, then it shows up and starts to move. This leads one to believe that it"s not doing anything, but just be patient. If you are using an MD380, they are typically Mode D in the modem settings. Also don't forget to set and save your TX and RX frequencies in the AutoCal box as well this information is not carried over from initial setup.
George Cotton, WB5JJJ
Russellville, Arkansas USA

Post Reply