Firmware update SUCCESS okay BUT

Post Reply
Riohondo65
Posts: 3
Joined: Wed Nov 15, 2017 10:43 pm

Firmware update SUCCESS okay BUT

Post by Riohondo65 » Wed Jun 05, 2019 1:10 pm

Hi,

I did firmware update to latest version on openspot legacy version 141. I got a SUCCESS message and it when through light changes and now it is stuck with the following lights

STATUS flashing red
ACT flashing green
MODEM no light
ETH ACT no light

I did a factory Reset and the same lights above happened. I went and installed the firmware 141 again and it gave a SUCCESS message. It went through the lights and again it got stuck same as above.

Any suggestions.

Also I can not access through router because it has not detected it is connected. Yes my computer and Openspot are connected to same router.

Riohondo65
Posts: 3
Joined: Wed Nov 15, 2017 10:43 pm

Re: Firmware update SUCCESS okay BUT

Post by Riohondo65 » Wed Jun 05, 2019 1:32 pm

I found out what the problem was.

W0DQ
Posts: 6
Joined: Thu Jun 06, 2019 12:32 am

Re: Firmware update SUCCESS okay BUT

Post by W0DQ » Sat Jun 08, 2019 1:23 pm

I'm not along. A local DMR user has the same problem. It's something in Windows 10., not eh browsers.

Post Reply