Page 1 of 1

Firmware update SUCCESS okay BUT

Posted: Wed Jun 05, 2019 1:10 pm
by Riohondo65
Hi,

I did firmware update to latest version on openspot legacy version 141. I got a SUCCESS message and it when through light changes and now it is stuck with the following lights

STATUS flashing red
ACT flashing green
MODEM no light
ETH ACT no light

I did a factory Reset and the same lights above happened. I went and installed the firmware 141 again and it gave a SUCCESS message. It went through the lights and again it got stuck same as above.

Any suggestions.

Also I can not access through router because it has not detected it is connected. Yes my computer and Openspot are connected to same router.

Re: Firmware update SUCCESS okay BUT

Posted: Wed Jun 05, 2019 1:32 pm
by Riohondo65
I found out what the problem was.

Re: Firmware update SUCCESS okay BUT

Posted: Sat Jun 08, 2019 1:23 pm
by W0DQ
I'm not along. A local DMR user has the same problem. It's something in Windows 10., not eh browsers.