Page 1 of 1
Posted: Sun Mar 26, 2017 10:36 pm
For some reason I can no longer switch rooms with my FT2D using DTMF.
I reset the openSpot back to factory and down graded the firm ware to 108 still no luck.
Posted: Mon Mar 27, 2017 6:43 am
Please make sure you switch rooms by pressing the "Special command/cross mode private call DTMF code" before entering the room number. It is set to * by default, you can change this on the Settings page, C4FM settings section.
This means if you want to switch to room 99, you have to send *99.
Posted: Mon Mar 27, 2017 11:30 am
Yes that is how I do it
Posted: Mon Mar 27, 2017 11:46 am
I have just tested the DTMF with my FT2D and works every time.
My software version is 108.
Check that your Modem is set to C4FM.
I made this mistake with my first test.
Had been using openSPOT in cross mode DMR to C4FM.
Posted: Mon Mar 27, 2017 8:34 pm
Checked modem is set for c4fm also tried it with the FTM-100d still no go
I have 2 openspot's they were both upgraded to the latest beta firmware that's when I
noticed the problem so I down grade back to 108 but no DTMF control.
Posted: Tue Mar 28, 2017 8:55 am
The latest stable and beta fw is 108. I can't reproduce the issue, it works for me all the time with an FT1D, FT2D and FTM100.
Does your call show up in the call log on the status page?
Posted: Tue Mar 28, 2017 1:18 pm
Yes it does
What I meant to say I downgraded to 101 and had the same problem and then went back to 108.
Thank-you for your time, I may have to just switch rooms with the computer.
Posted: Wed Mar 29, 2017 7:39 am
Make sure you use DN mode as openSPOT can only decode DTMF on DN calls.
Posted: Wed Mar 29, 2017 11:35 am
Yes i'am using DM
Posted: Wed Mar 29, 2017 2:50 pm
Can you please show us the openSPOT USB serial console log of a call when you transmit the DTMF?