Rf shark openspot stuck in "updating sortware mode"

Post Reply
retroman74
Posts: 1
Joined: Tue Apr 04, 2017 10:24 pm

Rf shark openspot stuck in "updating sortware mode"

Post by retroman74 »

I log into openspot local put in the password it opens up my RF shark and then says it's in "updating firmware mode" and never comes out of that mode. The lights on the shark from left to right: 1)blinks red 2)blinks red and green 3)blinks 1 quick flash of red 4) hard blinks green. Please before i send it back is there anyone that noes how to figure this out , please let me no.

User avatar
WB5JJJ
Posts: 79
Joined: Sun Dec 04, 2016 8:06 pm

Re: Rf shark openspot stuck in "updating sortware mode"

Post by WB5JJJ »

Sounds like you unplugged the USB before the firmware update was complete. With it unplugged, press the reset button while plugging in the USB for at least 10 seconds to restore the default firmware.
George Cotton, WB5JJJ
Russellville, Arkansas USA

User avatar
zelthian
Posts: 109
Joined: Thu Mar 02, 2017 10:59 pm
Location: Centennial, CO
Contact:

Re: Rf shark openspot stuck in "updating sortware mode"

Post by zelthian »

This thread should be in "troubleshooting".

User avatar
HA2NON
SharkRF team
SharkRF team
Posts: 4701
Joined: Fri Mar 25, 2016 3:33 pm
Contact:

Re: Rf shark openspot stuck in "updating sortware mode"

Post by HA2NON »

Yes, seems like the firmware upgrade did not complete correctly. Flash the firmware again.
Norbert "Nonoo" Varga, HA2NON
SharkRF Team

Post Reply