Post Reply
Posts: 1
Joined: Sun Nov 11, 2018 10:54 pm


Post by jcmarrero »

I am new to DMR and my new apartment is in a dead-zone for RF (high voltage power cables). So, I got an openSPOT2 to use DMR from home. What is the best way to configure my openSPOT2 for DMR-MARC network? Currently using DMR dongle connector, but I must be doing something wrong … I can see messages going out and I can use openSpot 2 Parrot, but no traffic heard and no contacts … Thank you, N2IPE.

User avatar
SharkRF team
SharkRF team
Posts: 5293
Joined: Fri Mar 25, 2016 3:33 pm

Re: DMR-MARC Setup

Post by HA2NON »

You can use the Homebrew/MMDVM connector in the Quick Setup. Set the Protocol mode to MMDVM mode and then it'll list DMR-MARC and also IPSC2 servers.
Norbert "Nonoo" Varga, HA2NON
SharkRF Team

Post Reply