Page 1 of 1

Unlink Command on DStar

Posted: Tue Nov 27, 2018 5:28 pm
by MG64
I just received my new Openspot 2 yesterday and I am getting ready to configure the setup on the device. This morning I was talking to a ham friend and he has an OS2 now for two weeks and is working fine for him. However, he informed me that he could not find how to disconnect off a reflector/repeater using the unlink command. Is this done by clear logs? With DMR you use a 4000 command to unlink from talk groups. What command or setup do you use for the Openspot 2 using DStar, since I'm getting mine setup for use?

Re: Unlink Command on DStar

Posted: Tue Nov 27, 2018 5:49 pm
by HA2NON
The openSPOT2 is designed to be always online so the unlink command is not supported. Just leave it plugged in and online.

If this bothers you, you can switch to a configuration profile which has the Null connector as the active connector.