Page 1 of 1

Anytone D878UV DMR radio setup for openspot2

Posted: Mon May 27, 2019 9:16 pm
by John4CA
Sorry for the newbie question, but is there a more detailed guide (with screenshots) for configuring the D878UV radio to use the openspot2?

I got the openspot2 setup working fine starting with my iPhone and now using Windows browser web interface. Thank you!
My radio is working ok, and I am using the CPS software to add channels, etc. to the 878 for the openspot2. I've read your written "DMR radio setup" 1/3 page guide, but I can't seem to find the options and settings that are described there.

Re: Anytone D878UV DMR radio setup for openspot2

Posted: Mon May 27, 2019 9:18 pm
by John4CA
Moderator: can you move this thread please to the new openSPOT2 board? Sorry.

Re: Anytone D878UV DMR radio setup for openspot2

Posted: Tue May 28, 2019 2:07 pm
by N0FXQ
I've attached an example screen capture of how I set up TAC310 in my Anytone D878. A few things to note...
* The channel name begins with HS. I use that naming convention to identify it as a Hotspot channel.
* The receive and transmit frequencies are the same. Use some care here in selecting frequencies that are not in conflict with public use frequencies in your state / local area. These frequencies will also be programmed into the OS2 on the Modem page | Frequency.
* Use Low power.
* Band Width is 12.5K
* TX Permit is Different Color Code
* The Receive Group List is Hotspot. I created this Receive group list to include TG9 so that messages transmitted by the OS2 will be heard on the Anytone.

Re: Anytone D878UV DMR radio setup for openspot2

Posted: Tue May 28, 2019 4:53 pm
by John4CA
Thank you!