How to setup for update
How to setup for update
I am following firmware update instructions. No where does it say disconnect from internet or don't disconnect. This may or may not be important. Videos show it disconnected, does it need to be disconnected or not? Really quite tired of screwing with this.
Re: How to setup for update
As soon as you execute the reboot to bootloader command then it will be disconnected, only the USB host will be active.
Brian G8SEZ
Re: How to setup for update
Thanks Brian, I will try once again. With the advent of Peanut it is becoming a mute point.
John W8NEE John
John W8NEE John
Re: How to setup for update
David has discontinued development of Peanut and turned off the server. Saw something about it on Twitter.
I know nothing about Peanut.
I know nothing about Peanut.
Brian G8SEZ
Re: How to setup for update
FYI, David recanted and has posted an update at the App Store, looks like it will continue, worked 2 stations early today. I'm still wanting to do the update rather than just let the openspot gather dust. Most troubling is the flashing RED status led.
73 John W8NEE
73 John W8NEE
Re: How to setup for update
The firmware upgrade is done through the USB cable. It does not matter if you have an Ethernet cable connected or not. Make sure you use a USB cable which supports data transfer, not just charging to connect the openSPOT to your computer.
Norbert Varga, HA2NON
SharkRF Team
SharkRF Team