2 posts • Page 1 of 1
I have an openspot2 that I can’t get to go into access mode. I’ve tried to reset to “factory settings” by holding the reset button until the LED goes out usually about 3-4 minutes. When I do I displays a CGNM-D8D8 device. It wants a password and don’t know what to enter. I’ve tried to hold the reset button to get to access doesn’t work. It either blinks red or will blink red/amber. What do I need to do to get it working? I don’t get anything but a message to the affect of no server when go to openspot2.local. As best I have been able to figure out when I push the reset button for 3 seconds I toggle off/on the CGNM-D8D8 device. Which apparently is the proble I don’t have a password for that. How can I get rid of that and get back to the Openspot2 access?