D-Star / DMR on Shark Openspot1

[zs6eli]

Hi, I recently purchased an Icom ID-31E. I currently use my TYT MD380 with my Openspot 1. What do I need to do to use both on the same Openspot, is that possible? I want to be able to talk on D-star and other times with the TYT on DMR.
73
Evan
ZS6ELI

[HA2NON]

Yes, it's possible. For D-STAR, activate a D-STAR connector (ex. REF/XRF or DCS/XLX). For DMR, activate a DMR (or C4FM if you want to cross mode) connector.

[zs6eli]

Hi Norbet

So I got my Openspot 1 to work with D-star and still have the DMR setting programmed into the Openspot.

If I wanna do some DMR do i need to enter the interface and change and edit the connector etc?

Thanks
Evan
ZS6ELI

[HA2NON]

You can use the web interface, or set up 2 configuration profiles, one for DMR and one for D-STAR, and you can switch between these 2 configuration profiles using your transceiver.

[Jerry]

I have been having trouble getting my OS1 to work on DMR. It works fine in crossmode from C4FM, but
using a DMR radio I cannot get it to work. I tried all settings on the modem A-F, no luck.
The Autocal does not "see" any signal. It does receive DMR calls from the Internet just fine.
Do you have any idea why I cannot transmit? My Brandmeister passwords are all set up and
working fine on other hotspots.

Jerry

[HA2NON]

Make sure both TX and RX frequencies are set to the same value both on the OS1 and your transceiver, otherwise your transceiver won't transmit (it expects a repeater on the frequency).

Does the built-in echo service on DMR ID 9999 work?
If not, switch both RX & TX frequencies, then re-do AutoCal or DMR demod mode switch.