For some reason I can no longer switch rooms with my FT2D using DTMF.
I reset the openSpot back to factory and down graded the firm ware to 108 still no luck.
DTMF
Re: DTMF
Please make sure you switch rooms by pressing the "Special command/cross mode private call DTMF code" before entering the room number. It is set to * by default, you can change this on the Settings page, C4FM settings section.
This means if you want to switch to room 99, you have to send *99.
This means if you want to switch to room 99, you have to send *99.
Norbert Varga, HA2NON
SharkRF Team
SharkRF Team
Re: DTMF
Hi,
I have just tested the DTMF with my FT2D and works every time.
My software version is 108.
Check that your Modem is set to C4FM.
I made this mistake with my first test.
Had been using openSPOT in cross mode DMR to C4FM.
73's
Martin
G8KOE
I have just tested the DTMF with my FT2D and works every time.
My software version is 108.
Check that your Modem is set to C4FM.
I made this mistake with my first test.
Had been using openSPOT in cross mode DMR to C4FM.
73's
Martin
G8KOE
Re: DTMF
The latest stable and beta fw is 108. I can't reproduce the issue, it works for me all the time with an FT1D, FT2D and FTM100.
Does your call show up in the call log on the status page?
Does your call show up in the call log on the status page?
Norbert Varga, HA2NON
SharkRF Team
SharkRF Team
Re: DTMF
Make sure you use DN mode as openSPOT can only decode DTMF on DN calls.
Norbert Varga, HA2NON
SharkRF Team
SharkRF Team
Re: DTMF
Can you please show us the openSPOT USB serial console log of a call when you transmit the DTMF?
Norbert Varga, HA2NON
SharkRF Team
SharkRF Team