Auto0-calibrate does not start

Post Reply
K2UNI
Posts: 3
Joined: Mon Jun 11, 2018 7:26 pm

Auto0-calibrate does not start

Post by K2UNI » Mon Jun 11, 2018 7:36 pm

I'm trying to set up an OpenSPOT with an AnyTone AT-D868UV. I think I have the radio set up property to trigger the DMR auto-calibrate function, but it doesn't start. I was able to hear and transmit to TAC-310 so I suspect the overall connection is OK, so is there something I need to set up in the channel I use to calibrate? Thanks - Keith K2UNI

User avatar
HA5OGR
Posts: 252
Joined: Sat Mar 26, 2016 7:32 pm
Location: Dunavarsány
Contact:

Re: Auto0-calibrate does not start

Post by HA5OGR » Tue Jun 12, 2018 5:39 am

Openspot and radio frequency must be the same. Please check it out! After setting up the DMR autocal connector, do not forget to click on the "Switch to selected" button. When the calibration process is over save the setting.
Attachments
DMR autocall-1.jpg
DMR modem settings.jpg
Calibrating in progress.jpg
DMR modem settings.jpg
73 de Lajos
Openspot alpha tester
Image

User avatar
HA2NON
SharkRF team
SharkRF team
Posts: 2820
Joined: Fri Mar 25, 2016 3:33 pm
Contact:

Re: Auto0-calibrate does not start

Post by HA2NON » Tue Jun 12, 2018 7:15 am

If autocal does not start then you can manually try each DMR demod mode on the modem page to find out which has the best audio quality.
Norbert "Nonoo" Varga, HA2NON
SharkRF Team

K2UNI
Posts: 3
Joined: Mon Jun 11, 2018 7:26 pm

Re: Auto0-calibrate does not start

Post by K2UNI » Tue Jun 12, 2018 2:31 pm

Thank you! I went through everything and found a couple of wrinkles, and now Autocal works.

skip chaser
Posts: 2
Joined: Sun Jun 24, 2018 5:57 pm

Re: Auto0-calibrate does not start

Post by skip chaser » Mon Jun 25, 2018 2:33 am

HI WHAT WAS THE WRINKLES AS IM HAVING THE SAME PROBLEM WITH A ANYTONE D868

THANKS

Post Reply