SharkRF community forums

I always take a openspot 2 with me in my car, but wanted to put somewhere where. I have a 3D printer, so i made a holder for it. There are two versions, one with mouting holes and one without ( use double sided tape to attach somewhere )

https://www.thingiverse.com/thing:4660714

Hi,

Did you ever do any updates on the holder..??

Thanks 73

Hello,

Both my openspots are fitting the holder. No need to update the 3D file. Or do you have an update for it ?

No update...
Just wanted to check before a friend prints it

I did think of some form of clips to keep cable neatly down the side
But probably not needed..

Thanks.. 73